HeatCoolHQ heatcoolhq.com (888) 217-3739

Franklin, NH

Heat Pump Repair and Replacement in Franklin, NH

Heat pump repair in Franklin, NH starts by telling a normal defrost cycle or auxiliary-heat run from one that is a fault. Franklin averages 174 days a year with a low of 32°F or colder and 84 at 20°F or colder (NOAA 1991–2020 normals, station in or next to town), and those colder days are when a heat pump leans on its backup heat. Half the homes in Franklin were built before 1958 (Census ACS 2019–2023), so in many of them the heating and cooling equipment has been replaced at least once while the ducts and the flue have not. Every split heat pump made since January 1, 2023 has to rate at least 14.3 SEER2 for cooling and 7.5 HSPF2 for heating, the same federal minimum in every state.

(888) 217-3739

New Hampshire contractors. No obligation for the call.

The year in Franklin—heating runs most of the year
The year in Franklin. heating runs most of the year. Between the two seasons there are weeks when neither system runs, which is when a fault goes unnoticed. BELOW FREEZINGBELOW FREEZINGnothing runsJFMAMJJASOND
heatingcoolingbelow freezing174 days below freezing · July dew point 60°F
A technician checking the coil of an outdoor heat pump in winter
The top grille off, frost across the coil. A heat pump melts that off on a schedule of its own, which looks like a fault and is not.

Air that feels cool at the vents in winter is usually the heat pump working as designed, and a heat pump that sits on auxiliary heat for hours in mild weather usually is not. Say what the thermostat is showing and a heating and cooling contractor can come out to Franklin and tell the two apart.

In Franklin a heat pump is a decision rather than the default, where the usual arrangement is a furnace with an air conditioner beside it, and the trade-off behind that decision is real: the heating season runs long enough that the hours when the machine is weakest add up to a season of their own. What moved in the last ten years is where those hours begin. A single-stage heat pump installed in 2010 lost output as the temperature dropped and handed most of January to its backup, while cold-climate inverter models hold much of their rated heating output down near 5°F — so the heat pump somebody remembers from an earlier winter and the one a contractor installs now are not the same machine.

A winter this long also makes the defrost cycle impossible to miss. The outdoor coil collects frost in heating mode, and the system reverses for a few minutes to clear it — which is why steam rolls off the unit on a cold morning, why the outdoor fan stops, and why the backup heat comes on for the length of it. A fault looks different from that: a sheet of ice that never clears, or ice building up around the base, which usually means the meltwater has nowhere to drain and the unit sits too low. Ice comes off with warm air or with time, never with a screwdriver — the tubing in that coil is thin, and a puncture turns a defrost fault into a refrigerant leak.

Nights below 20°F come often enough here that the auxiliary strips do real work, so a January bill above October's is the equipment behaving as designed rather than a fault. A failed element inside that bank is the version worth knowing about — several elements share one breaker, so the rest carry on, the house falls behind only on the coldest nights, and the heat pump itself tests fine.

Franklin, NH in numbers

Days a year with a low of 32°F or colder174NOAA 1991–2020 normals, station in or next to town
Days a year with a low of 20°F or colder84NOAA 1991–2020 normals
Average July dew point60°FPRISM 1991–2020 normals
Median year homes were built1958Census ACS 2019–2023
Households3,596Census ACS 2019–2023
CountyMerrimack CountyCensus Bureau
Federal minimum for a new split central AC13.4 SEER2 (North region)DOE, 2023 standard

Why heat pumps do not fix themselves

What makes a heat pump different is that it can fail without ever going quiet. A machine low on refrigerant, or one whose defrost control has stopped working, does not stop making heat — it falls behind, and the backup heat fills the gap without being asked. The thermostat still reads what it is set to, so the fault turns up on the electric bill rather than in the house. In cooling the same shortfall is easier to spot, because nothing covers for it — which is why a heat pump often gets diagnosed in summer for something it had been doing all through the heating season.

A technician at an indoor air handler

When to stop and call in Franklin

  • The thermostat sits on auxiliary or emergency heat for hours while it is mild outside.
  • The breaker feeding the outdoor unit or the air handler will not stay in.
  • Refrigerant was added in an earlier season and the system is behaving the same way again.
The license
Held by the contractor, not by this site, and issued where the work happens — New Hampshire licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.

What the visit involves

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

What to have ready when you call

  1. 01That it is a heat pump, and what the backup is — electric, or a gas furnace on the same ducts, and not knowing is a fair answer.
  2. 02Roughly what year it went in, and the refrigerant from the outdoor data plate — R-410A on most systems in service, R-454B on recent ones.
  3. 03What the unit outside is doing: iced over, silent, running without stopping, or reversing every few minutes.

If the house has gone cold, emergency heat is what that setting is for — say on the phone that you switched to it, because it locks out the compressor, and the fault a technician needs to watch stops happening while it is on.

Heat Pumps in Franklin: questions

How many freezing days does Franklin have?

Franklin averages 174 days a year with a low of 32°F or colder and 84 at 20°F or colder, by the 1991–2020 climate normals for the NOAA station in or next to town. A winter that long leans on the backup heat, so a heat pump here is sized and set up for the cold half of the year.

What is the July dew point in Franklin?

The July dew point in Franklin averages 60°F, by the PRISM 1991–2020 climate normals. In air that dry most of the cooling load is heat, and an air conditioner removes little water, so sizing turns on the house and its sun more than on humidity.

How efficient must a new heat pump in Franklin be?

A split heat pump made since January 1, 2023 has to rate at least 14.3 SEER2 for cooling and 7.5 HSPF2 for heating under the federal standard, and the minimum is the same in every state, New Hampshire included. A contractor can quote above the minimum; the rating is on the unit's label and on the AHRI certificate for the matched pair.

Map loads when you reach it

Other services in Franklin

Heat Pumps nearby

Call (888) 217-3739