Follett, TX
Ductwork and Airflow in Follett, TX
Duct repair in Follett, TX starts with measuring the airflow at the registers and the static pressure at the air handler. Half the homes in Follett were built before 1960 (Census ACS 2019–2023), and ducts in houses that age were often added or extended long after they were built. Follett has an average July dew point of 61°F (PRISM 1991–2020 normals), so moisture is a smaller part of the cooling load here than heat. Under the 2021 International Energy Conservation Code, a new duct system may leak no more than 4 cubic feet of air a minute per 100 square feet of floor area at the post-construction test, where the state or town has adopted that edition.
(888) 217-3739Texas contractors. No obligation for the call.
One room that is always wrong while the thermostat says the house is fine usually points at the duct rather than at the equipment. Say which room and in which season, and an independent contractor can come out to Follett and measure the airflow instead of guessing at it.
Both seasons are real in Follett, so one duct system has to satisfy two opposite jobs. Warm air rises and cold air sinks without any help from the blower, so the same register opening that leaves an upstairs room hot in July leaves it fine in January.
That hands you a test a warmer place never gets. A room weak in both seasons is the run itself — crushed, pulled off its collar, undersized, or leaking into somewhere that is not the house. A room that is wrong in only one of the two seasons is a balance question, and dampers and register settings are where that gets settled.
A leaking return in an attic or a crawl space pulls outdoor air into the system at the dew point outdoors, and the coil deals with that air before it deals with any room. The heating side pays for the same leak in winter, and no room feels wrong in either season while it happens. In this climate the coil still spends most of its work on temperature rather than on moisture, so the temperature split measured across it reads mostly as airflow — one reading at the air handler is worth more than an afternoon of opening and closing registers.
Follett, TX in numbers
| Days a year with a low of 32°F or colder | 117 | NOAA 1991–2020 normals, station in or next to town |
|---|---|---|
| Days a year with a low of 20°F or colder | 38 | NOAA 1991–2020 normals |
| Average July dew point | 61°F | PRISM 1991–2020 normals |
| Median year homes were built | 1960 | Census ACS 2019–2023 |
| Households | 133 | Census ACS 2019–2023 |
| County | Lipscomb County | Census Bureau |
| Federal minimum for a new split central AC | 14.3 SEER2 under 45,000 Btu/h (Southeast) | DOE, 2023 standard |
Before you try the store-bought fix
Duct tape is named after the job it fails at. The cloth-backed roll dries out on a warm duct and releases, usually within a couple of years, and the joint is open again with nothing to show for the afternoon. What holds is mastic brushed on, or foil tape carrying a UL 181 marking on the roll — and both want the joint clean and dry, which is the hard part in a crawl space.
Signs it is time to call
- A return grille whistles or roars, or the filter bows inward when the blower starts.
- There is a stain on a ceiling under a duct run, or duct insulation that is wet to the touch.
- Ice on the line at the air handler, or the system shutting itself off and starting again within the hour.
- The license
- Held by the contractor, not by this site, and issued where the work happens — Texas licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
- The figure
- Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
- Coverage
- By town, not by region. Follett and the towns around it, and it shifts with who is taking calls at the hour you ring.
What a visit in Follett involves
- 01
The diagnosis
At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.
- 02
The finding, out loud
What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.
- 03
The repair
Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.
What to have ready when you call from Follett
- 01Which rooms are weak, and whether it happens in heating, in cooling, or in both — that one answer narrows it before anybody arrives.
- 02The filter size, and how long the one in the slot has been there, and whether any register or damper has been closed.
- 03Where the duct runs — a basement, a vented crawl space, an attic, or entirely inside the house.
Do not go around opening and closing registers before the visit — a technician measures the system as it actually runs, and one damper moved this morning shifts every reading this afternoon.
Ductwork in Follett: questions
How old are the homes in Follett?
Half the homes in Follett were built before 1960, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up almost all of the housing. Ducts in houses that age were often added after the house was built, sized for heat rather than for cooling.
How humid are summers in Follett?
The July dew point in Follett averages 61°F, by the PRISM 1991–2020 climate normals. In air that dry most of the cooling load is heat, and an air conditioner removes little water, so sizing turns on the house and its sun more than on humidity.
How efficient must a new air conditioner in Follett be?
A new split central air conditioner in Follett falls under DOE's 2023 standard for the Southeast: at least 14.3 SEER2 below 45,000 Btu/h. In the Southeast the rule follows installation: a unit below the standard cannot be connected after January 1, 2023, whenever it was made.