Florence, TX
Furnace Replacement and Installation in Florence, TX
Furnace replacement in Florence, TX turns on three things: when the furnace went in, what failed, and how much heat the house actually needs. Florence has, on average, 28 days a year with a low of 32°F or colder and 2 at 20°F or colder (NOAA 1991–2020 normals, station 12 miles away). Half the homes in Florence were built before 1975 (Census ACS 2019–2023). The federal minimum for a new non-weatherized gas furnace is an AFUE of 80, and a 95 standard for furnaces made after December 18, 2028 is still in court.
(888) 217-3739Texas contractors. No obligation for the call.
A furnace with one failed part and a furnace on its second service call of the season are asking different questions. Say when it went in, roughly, and what it is doing now, and a heating contractor can come out to Florence and answer that before anything is ordered.
What low hours change is the way a furnace ends, not whether it ends. A furnace here stands still more than it runs: a flue that never gets hot enough to dry itself out, condensate sitting in a trap through a warm winter, corrosion working on the burners from the outside in. Corrosion reaches the heat exchanger before cycling would have, and the ending is the same one.
From one house to the next here, the indoor cabinet is not the same thing: a small gas furnace in a closet or out in the garage in one, an air handler with electric resistance strips behind a heat pump in the next. The model number on the data plate settles which, and it settles what the visit is — a furnace changeout and an air handler changeout are not the same piece of work.
The cooling coil sits directly on top of the furnace in an upflow cabinet, and in a summer like this it runs wet for months at a time. Everything it takes out of the air leaves through one drain line, and a blocked line leaves the water one place to go: rust across the top of a heat exchanger is often a story about the cooling season rather than the heating one. It is worth saying on the call, because it changes what a contractor expects to find when the cabinet comes open.
Florence, TX in numbers
| Days a year with a low of 32°F or colder | 28 | NOAA 1991–2020 normals, station 12 miles away |
|---|---|---|
| Days a year with a low of 20°F or colder | 2 | NOAA 1991–2020 normals |
| Average July dew point | 68°F | PRISM 1991–2020 normals |
| Median year homes were built | 1975 | Census ACS 2019–2023 |
| Households | 423 | Census ACS 2019–2023 |
| County | Williamson County | Census Bureau |
| Federal minimum for a new split central AC | 14.3 SEER2 under 45,000 Btu/h (Southeast) | DOE, 2023 standard |
What the hardware-store fix does and does not do
A fresh filter is the one thing off the shelf that genuinely does something, and it is worth being exact about what it reaches. A loaded filter chokes the air moving across the heat exchanger until the limit switch opens on temperature, and from the hallway that looks like a furnace that has died. A technician rules that out first as well, along with a flame sensor filmed over enough to make the burners light, drop out a few seconds later, try again, and lock out on the third attempt. A furnace that has been through both and still stops is not a parts question any more.
Signs it is time to call
- A technician has said the words heat exchanger, or a carbon monoxide alarm has gone off.
- Flame rolls out of the burner opening, or there is soot around the furnace door.
- The part it needs is on back order and the furnace was installed before 2010.
- The license
- Held by the contractor, not by this site, and issued where the work happens — Texas licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
- The figure
- Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
- The call
- Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
What a visit in Florence involves
- 01
The diagnosis
At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.
- 02
The repair
Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.
- 03
What happens after
A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.
What to have ready when you call from Florence
- 01When the furnace went in, roughly, and its model number — the data plate inside the door carries both.
- 02What the furnace is doing now — no heat at all, short cycling, a noise that started recently, or burners that light and drop out.
- 03Whether cooling runs through the same ductwork, and what the outdoor data plate gives as the refrigerant — R-410A, R-454B or R-22 — and the model number on that unit, which tells a contractor whether it only cools or heats as well.
Have the data plate from inside the furnace door in front of you, because it answers half the call — the year it went in and the model number. And if the gas utility left a tag on the appliance, leave the tag where it is: it names what has to be put right before the gas comes back.
Furnace Replacement in Florence: questions
How many freezing days does Florence have?
Florence averages 28 days a year with a low of 32°F or colder and 2 at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 12 miles away. Heating is rarely asked for here, so a fault in it can sit unnoticed until the one cold week of the year.
When were most houses in Florence built?
Half the homes in Florence were built before 1975, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up most of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made. Manufactured homes are common enough here that a packaged unit outside, feeding a duct under the floor, is worth mentioning on the call.
Is there still a federal tax credit for a new furnace?
No: under the tax law signed on July 4, 2025, the 25C credit does not apply to equipment installed after December 31, 2025. A quote that still counts it is out of date; a utility or state rebate is a separate program, and the contractor or the utility can say whether one applies.
Other services in Florence
Furnace Replacement nearby