Exeter, MO
Furnace and Heating Repair in Exeter, MO
Heating repair in Exeter, MO comes down to finding the step where the furnace or heat pump stops in its start-up sequence. Exeter has, on average, 110 days a year with a low of 32°F or colder and 37 at 20°F or colder (NOAA 1991–2020 normals, station 4 miles away). Half the homes in Exeter were built before 1985 (Census ACS 2019–2023). When the gas utility finds a leak or an unsafe furnace it shuts the gas off and tags the appliance, and only a repair brings the gas back.
(888) 217-3739Missouri contractors. No obligation for the call.
No heat on a cold night comes down to a short list of faults, and the step where the sequence stops names the part. Say what heats the house, what the thermostat is asking for against what it says the room is, and what the equipment is actually doing, and a heating contractor who covers Exeter takes it from there.
In Exeter both halves of the system work a real season, and both age on the same clock. The furnace and the air conditioner usually share one blower, one filter and one set of ducts, so what the cooling season did shows up when the blower has to move heated air again.
The fault list is short: flame sensor, ignitor, pressure switch, limit switch, a filter starving the blower, a thermostat that lost its common wire. What tells them apart is the order the equipment runs in — the inducer spins up first, the pressure switch proves it, the ignitor glows, the gas valve opens, and the flame has to prove itself within seconds. A technician follows that order at the appliance, and the call is what puts one in front of it.
Where a heat pump does the heating, a cold snap puts it on its auxiliary heat strips — resistance heat, which a heat pump calls in below about 35°F, and a cold week spent on the strips turns up on the electric bill. What makes that a repair question is that the strips can hide a fault: a heat pump that has stopped heating still leaves a warm house, because the strips take the whole load and the thermostat never complains. Often the first sign is the bill rather than the cold, and by then the system has been running the expensive half of itself for weeks.
Exeter, MO in numbers
| Days a year with a low of 32°F or colder | 110 | NOAA 1991–2020 normals, station 4 miles away |
|---|---|---|
| Days a year with a low of 20°F or colder | 37 | NOAA 1991–2020 normals |
| Average July dew point | 67°F | PRISM 1991–2020 normals |
| Median year homes were built | 1985 | Census ACS 2019–2023 |
| Households | 326 | Census ACS 2019–2023 |
| County | Barry County | Census Bureau |
| Federal minimum for a new split central AC | 13.4 SEER2 (North region) | DOE, 2023 standard |
Heating faults do not fix themselves
A furnace that has to be reset to keep running is not a furnace that is working. Each lockout is a control board refusing to try again after a safety did not prove — the flame, the pressure switch or the limit — and a reset answers none of that. What a reset does change is the wear: a furnace short cycling through a cold week runs its ignition sequence dozens of times a day, and the ignitor and the inducer motor are the parts paying for it.
A heating tune-up before the season
A pre-season heating tune-up is the one visit booked on your schedule instead of the furnace's. In Exeter it belongs before the first cold night, because the faults that end a winter evening are mostly parts that were already wearing in October: an ignitor near the end of its starts, a flame sensor carrying last season's coating, a filter loaded through the cooling months, a condensate drain that has grown a film.
Signs it is time to call
- There is a smell of gas, or a carbon monoxide alarm has gone off — outside first, then the gas utility, then the repair call.
- There is a tag on the furnace and the gas supply has been shut off.
- The blower runs and the air never warms, or the thermostat is asking for heat while the reading keeps dropping.
- The license
- Held by the contractor, not by this site, and issued where the work happens — Missouri licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
- The call
- Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
- Coverage
- By town, not by region. Exeter and the towns around it, and it shifts with who is taking calls at the hour you ring.
What a visit in Exeter involves
- 01
The diagnosis
At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.
- 02
The finding, out loud
What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.
- 03
What happens after
A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.
What to have ready when you call from Exeter
- 01Which system it is: a furnace, a boiler with radiators or baseboard, or a heat pump with electric backup.
- 02Both numbers from the thermostat — the setting, and what it says the room is — and whether the screen has gone blank, because a thermostat wired without a common wire runs off its battery, and a dead battery looks exactly like a dead furnace.
- 03What it is doing: silent, clicking and stopping, lighting and dropping out, or running with cold air at the vents.
Do not keep pressing the reset while you wait — each press relights a furnace that shut itself down for a reason, and the lockout it is holding is the first thing a technician reads.
Heating Repair in Exeter: questions
How many freezing days does Exeter have?
Exeter averages 110 days a year with a low of 32°F or colder and 37 at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 4 miles away. Both halves of the system work hard here, and the heating side runs for months rather than weeks.
When were most houses in Exeter built?
Half the homes in Exeter were built before 1985, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up most of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made. Manufactured homes are common enough here that a packaged unit outside, feeding a duct under the floor, is worth mentioning on the call.
What efficiency does a new gas furnace in Exeter need?
A new non-weatherized gas furnace has to reach an AFUE of at least 80 under the federal minimum. DOE has set 95 for furnaces made after December 18, 2028, and that rule is still being fought in court, so a furnace installed now can still be an 80 or a condensing 90-plus.
Other services in Exeter
Heating Repair nearby