HeatCoolHQ heatcoolhq.com (888) 217-3739

Excel, AL

Ductwork and Airflow in Excel, AL

Ductwork and airflow problems in Excel, AL show up as one room too hot or too cold while the thermostat says the house is fine. Half the homes in Excel were built before 1985 (Census ACS 2019–2023). Excel has an average July dew point of 72°F (PRISM 1991–2020 normals), air wet enough that an air conditioner spends much of each cycle pulling water out of it. Under the 2021 International Energy Conservation Code, a new duct system may leak no more than 4 cubic feet of air a minute per 100 square feet of floor area at the post-construction test, where the state or town has adopted that edition.

(888) 217-3739

Alabama contractors. No obligation for the call.

The year in Excel—cooling leads, heating gets weeks
The year in Excel. cooling leads, heating gets weeks. Between the two seasons there are weeks when neither system runs, which is when a fault goes unnoticed. nothing runsJFMAMJJASOND
heatingcooling39 days below freezing · July dew point 72°F
A technician joining flexible duct to a metal trunk line in a crawl space
Flexible duct being strapped to the trunk line under the floor. What leaves the equipment and what arrives at the register are two different numbers.

A room that never gets comfortable while the rest of the house is fine is usually a duct problem rather than an equipment problem. Say which room and in which season, and an independent contractor can come out to Excel and measure the airflow instead of guessing at it.

In Excel cooling leads the year, and the installer sizes the duct around the cooling load — where anybody sized it at all. More often than not that works in your favor: a system with a furnace moves less air in heating than it moves in cooling, and a heat pump moves the same air in both, so a run sized to carry the house through August usually carries it through the few cold weeks either way.

The heating season here is short enough that a weak room gets tolerated — a few weeks of a back bedroom nobody sits in, and then it is spring. That same run is the one that will not cool in July, and by then it has been wrong for a year. It is usually the room at the end of the longest run, which is the one the air reaches last in either season.

The July air here is humid enough to give the duct a problem a dry climate never has: a supply run crossing an unconditioned attic or crawl space carries air near 55°F through air whose dew point is above 70°F, and where the insulation is torn, compressed or missing, the duct sweats. The water collects at the bottom of the run, and it turns up a floor below, some distance from the joint that made it. A return leaking in the same space does the other half — it draws that outside air in at its own dew point, and the coil spends its capacity drying attic air while the house stays cool and clammy.

Excel, AL in numbers

Days a year with a low of 32°F or colder39NOAA 1991–2020 normals, station 18 miles away
Days a year with a low of 20°F or colder2NOAA 1991–2020 normals
Average July dew point72°FPRISM 1991–2020 normals
Median year homes were built1985Census ACS 2019–2023
Households170Census ACS 2019–2023
CountyMonroe CountyCensus Bureau
Federal minimum for a new split central AC14.3 SEER2 under 45,000 Btu/h (Southeast)DOE, 2023 standard

Duct problems do not fix themselves

The cold room is the symptom people call about, and it is the smaller half of the problem. A return that is too small, or a run that has collapsed, raises the pressure the blower works against, and the blower works against it every hour the system runs — in the rooms that are fine as much as in the room that is not.

A technician at an indoor air handler

Signs it is time to call

  • The filter is clean, every register is open, and one room is still wrong.
  • A room has never been comfortable since the system was replaced.
  • There is a stain on a ceiling under a duct run, or duct insulation that is wet to the touch.
The license
Held by the contractor, not by this site, and issued where the work happens — Alabama licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
Coverage
By town, not by region. Excel and the towns around it, and it shifts with who is taking calls at the hour you ring.

What the visit involves

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

Before you call: what to have ready

  1. 01Which rooms are weak, and whether it happens in heating, in cooling, or in both — that one answer narrows it before anybody arrives.
  2. 02The filter size, and how long the one in the slot has been there, and whether any register or damper has been closed.
  3. 03What the system is — furnace, heat pump, or a furnace with cooling added — and roughly what year it went in, and whether the installer replaced the duct with it or left it in place.

Leave the registers and dampers where they are before the visit — a technician measures the system as it actually runs, and one damper moved this morning shifts every reading this afternoon.

Ductwork in Excel: questions

How old are the homes in Excel?

Half the homes in Excel were built before 1985, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up almost all of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made.

What is the July dew point in Excel?

The July dew point in Excel averages 72°F, by the PRISM 1991–2020 climate normals. In air that wet an oversized air conditioner cools the house fast, shuts off before it has dried the air, and leaves rooms cool and clammy, which is why sizing starts with a load calculation for the house.

How much may a new duct system leak in Excel?

The 2021 International Energy Conservation Code allows a new duct system to leak no more than 4 cubic feet of air a minute per 100 square feet of floor area at the post-construction test. Whether that applies depends on the code edition Alabama or the town has adopted, and the building department can say which one.

Map loads when you reach it

Other services in Excel

Ductwork nearby

Call (888) 217-3739