Enemy Swim, SD
Furnace Replacement and Installation in Enemy Swim, SD
A new furnace in Enemy Swim, SD is sized from the house, its ducts and its winters, not from the rating plate of the one coming out. Enemy Swim averages 166 days a year with a low of 32°F or colder and 103 at 20°F or colder (NOAA 1991–2020 normals, station in or next to town). Half the homes in Enemy Swim were built before 1977 (Census ACS 2019–2023). A new non-weatherized gas furnace has to reach an AFUE of at least 80, the federal minimum; DOE has set 95 for furnaces made after December 18, 2028, a rule still being fought in court.
(888) 217-3739South Dakota contractors. No obligation for the call.
A furnace with one failed part and a furnace on its second service call of the season are asking different questions. Say when it went in, roughly, and what it is doing now, and a heating contractor can come out to Enemy Swim and answer that before anything is ordered.
Every time the burners light the steel expands, and every time they stop it contracts, and a crack is where that ends. That is not a failed part: the heat exchanger is the body of the machine rather than something bolted to it, and getting at one means stripping the furnace back to its cabinet. By then most of the decision has been made for you.
Which is why the month matters more here than almost anywhere. A changeout takes about one day, and for part of that day the house has no heat — an ordinary afternoon in September, a different proposition in January. A furnace that came through last winter on two repairs is worth raising in spring rather than in February.
The cooling coil sits directly on top of the furnace in an upflow cabinet, and in a summer like this it runs wet for months at a time. Everything it takes out of the air leaves through one drain line, and a blocked line leaves the water one place to go: rust across the top of a heat exchanger is often a story about the cooling season rather than the heating one. It is worth saying on the call, because it changes what a contractor expects to find when the cabinet comes open.
Enemy Swim, SD in numbers
| Days a year with a low of 32°F or colder | 166 | NOAA 1991–2020 normals, station in or next to town |
|---|---|---|
| Days a year with a low of 20°F or colder | 103 | NOAA 1991–2020 normals |
| Average July dew point | 62°F | PRISM 1991–2020 normals |
| Median year homes were built | 1977 | Census ACS 2019–2023 |
| Households | 83 | Census ACS 2019–2023 |
| County | Day County | Census Bureau |
| Federal minimum for a new split central AC | 13.4 SEER2 (North region) | DOE, 2023 standard |
Why furnaces in Enemy Swim do not fix themselves
A crack in a heat exchanger does not stay the size it was found at. It opens further on every heating cycle, because heat moves the steel and the crack is where that movement collects.
When to stop and call in Enemy Swim
- A technician has said the words heat exchanger, or a carbon monoxide alarm has gone off.
- Flame rolls out of the burner opening, or there is soot around the furnace door.
- The part it needs is on back order and the furnace was installed before 2010.
- The figure
- Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
- The call
- Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
- Coverage
- By town, not by region. Enemy Swim and the towns around it, and it shifts with who is taking calls at the hour you ring.
What the visit involves
- 01
The finding, out loud
What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.
- 02
The repair
Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.
- 03
What happens after
A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.
Before you call: what to have ready
- 01Roughly when the furnace was installed, and the model number — the data plate inside the door carries both.
- 02What the furnace is doing now — no heat at all, short cycling, a noise that started recently, or burners that light and drop out.
- 03Whether cooling runs through the same ductwork, and what the outdoor data plate gives as the refrigerant — R-410A, R-454B or R-22 — and the model number on that unit, which tells a contractor whether it only cools or heats as well.
The data plate inside the furnace door answers half the call, so have it in front of you — the year it went in and the model number. And if the gas utility left a tag on the appliance, leave the tag where it is: it names what has to be put right before the gas comes back.
Furnace Replacement in Enemy Swim: questions
How many freezing days does Enemy Swim have?
Enemy Swim averages 166 days a year with a low of 32°F or colder and 103 at 20°F or colder, by the 1991–2020 climate normals for the NOAA station in or next to town. Heating is the main system here, and a furnace that quits in January is an emergency rather than an inconvenience.
How old are the homes in Enemy Swim?
Half the homes in Enemy Swim were built before 1977, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up almost all of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made.
Does the federal tax credit still cover a new furnace in Enemy Swim?
No: under the tax law signed on July 4, 2025, the 25C credit does not apply to equipment installed after December 31, 2025. A quote that subtracts it is out of date, and any utility or state rebate is a separate program to ask the utility about.
Other services in Enemy Swim
Furnace Replacement nearby