HeatCoolHQ heatcoolhq.com (888) 217-3739

Dundee, OH

Heat Pump Repair and Replacement in Dundee, OH

A heat pump in Dundee, OH works in both seasons, so its repair or replacement starts with how it behaves in each. Dundee has, on average, 134 days a year with a low of 32°F or colder and 52 at 20°F or colder (NOAA 1991–2020 normals, station 11 miles away), and those colder days are when a heat pump leans on its backup heat. Half the homes in Dundee were built before 1938 (Census ACS 2019–2023), so in many of them the heating and cooling equipment has been replaced at least once while the ducts and the flue have not. Every split heat pump made since January 1, 2023 has to rate at least 14.3 SEER2 for cooling and 7.5 HSPF2 for heating, the same federal minimum in every state.

(888) 217-3739

Ohio contractors. No obligation for the call.

The year in Dundee—both systems work a real season
The year in Dundee. both systems work a real season. There is no month when both systems are idle. BELOW FREEZINGJFMAMJJASOND
heatingcoolingbelow freezing134 days below freezing · July dew point 63°F
A technician checking the coil of an outdoor heat pump in winter
The top grille off, frost across the coil. A heat pump melts that off on a schedule of its own, which looks like a fault and is not.

A heat pump blowing air that feels cool in winter is usually working as designed, and a heat pump that sits on auxiliary heat for hours in mild weather usually is not. Say what the thermostat is showing and a heating and cooling contractor can come out to Dundee and tell the two apart.

Where a furnace and a separate AC are two machines, one can fail and the other carries on: the furnace goes and the cooling still works all summer. A heat pump is both machines inside a single cabinet, so when the compressor goes, heating and cooling go together, and the decision that arrives is not about half a system. A climate with two real seasons leaves no long off season to push it into — the machine is wanted again within weeks, whichever way the weather is going.

Twice a year the machine has to change direction, and that is when the reversing valve gets tested — once in autumn and once in spring. A machine that heated all winter and then refuses to cool when the first warm week of May arrives is usually pointing at that valve, or at the control that tells it to move, rather than at the compressor. A spring failure is easy to put off, and that is the trap: the valve that would not move in May is the valve that has to move again in October, and a summer of leaving it alone does not fix it.

The frost on an outdoor coil comes out of the air, not off the ground, which is why the heaviest of it here arrives in weather nobody would call severe. A coil below freezing collects moisture from damp air faster than from cold dry air, so a drizzly morning near 35°F puts more ice on it than a clear night at 15°F does — and a defrost cycle on a mild wet morning is the machine keeping up rather than falling behind. Ice that is still sitting there at the end of the day is the fault version, and it does not clear itself.

Dundee, OH in numbers

Days a year with a low of 32°F or colder134NOAA 1991–2020 normals, station 11 miles away
Days a year with a low of 20°F or colder52NOAA 1991–2020 normals
Average July dew point63°FPRISM 1991–2020 normals
Median year homes were built1938Census ACS 2019–2023
Households220Census ACS 2019–2023
CountyTuscarawas CountyCensus Bureau
Federal minimum for a new split central AC13.4 SEER2 (North region)DOE, 2023 standard

Before you try the store-bought fix

The small can with a gauge on the top is a car product, and that is not an accident: a homeowner cannot buy R-410A or R-454B over the counter. The EPA restricts sales of those refrigerants to certified technicians, and the exception that keeps the can on the shelf is refrigerant for a car air conditioner. Even if a fitting could be made to work, a technician sets the charge by measurement rather than by what a gauge reads — superheat and subcooling, read at the machine, and read differently in heating mode than in cooling. And a working system does not consume refrigerant: a heat pump that needs more of it has a leak, so the work is finding the leak rather than replacing what escaped.

A technician at an indoor air handler

When to stop and call

  • The thermostat sits on auxiliary or emergency heat for hours while it is mild outside.
  • The breaker feeding the outdoor unit or the air handler will not stay in.
  • Refrigerant was added in an earlier season and the system is behaving the same way again.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
Coverage
By town, not by region. Dundee and the towns around it, and it shifts with who is taking calls at the hour you ring.

What the visit involves

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  3. 03

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

What to have ready when you call from Dundee

  1. 01That it is a heat pump, and what the backup is — electric, or a gas furnace on the same ducts, and not knowing is a fair answer.
  2. 02What the thermostat is set to, what it is reading, and whether it shows auxiliary or emergency heat.
  3. 03Roughly what year it went in, and the refrigerant from the outdoor data plate — R-410A on most systems in service, R-454B on recent ones.

If the house has gone cold, emergency heat is what that setting is for — say on the phone that you switched to it, because it locks out the compressor, and the fault a technician needs to watch stops happening while it is on.

Heat Pumps in Dundee: questions

How many freezing days does Dundee have?

Dundee averages 134 days a year with a low of 32°F or colder and 52 at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 11 miles away. Both seasons are real here, and the coldest weeks are when the backup strips or a furnace carry part of the load.

How humid are summers in Dundee?

The July dew point in Dundee averages 63°F, by the PRISM 1991–2020 climate normals. In air that wet an oversized air conditioner cools the house fast, shuts off before it has dried the air, and leaves rooms cool and clammy, which is why sizing starts with a load calculation for the house.

What efficiency does a new heat pump need in Dundee?

A split heat pump made since January 1, 2023 has to rate at least 14.3 SEER2 for cooling and 7.5 HSPF2 for heating under the federal standard, and the minimum is the same in every state, Ohio included. The rating of the matched outdoor unit and coil is on the AHRI certificate, and a quote for Dundee can go above the minimum.

Map loads when you reach it

Other services in Dundee

Heat Pumps nearby

Call (888) 217-3739