Cross Timber, TX
Furnace Replacement and Installation in Cross Timber, TX
A new furnace in Cross Timber, TX is sized from the house, its ducts and its winters, not from the rating plate of the one coming out. Cross Timber averages 39 days a year with a low of 32°F or colder and 4 at 20°F or colder (NOAA 1991–2020 normals, station in or next to town). Half the homes in Cross Timber were built in 2008 or later (Census ACS 2019–2023), so many houses here still run the equipment they were built with. A new non-weatherized gas furnace has to reach an AFUE of at least 80, the federal minimum; DOE has set 95 for furnaces made after December 18, 2028, a rule still being fought in court.
(888) 217-3739Texas contractors. No obligation for the call.
A furnace that has failed once and a furnace on its second service call this season are two different questions. Say when it went in, roughly, and what it is doing now, and a heating contractor can come out to Cross Timber and answer that before anything is ordered.
A furnace in Cross Timber runs a fraction of the hours one further north does, and that shows in how it fails. It rarely wears out — it sits idle for most of the year, and the first cold evening asks it to start.
So the replacement question usually arrives from the cooling side. A compressor fails in August, or the indoor coil leaks, and the cabinet comes apart for reasons that have nothing to do with heat — and the furnace stands there in the open, data plate showing, while the AC work goes on around it. The furnace did not cause the call, and it is still part of what gets decided that day.
The cooling coil sits directly on top of the furnace in an upflow cabinet, and in a summer like this it runs wet for months at a time. Everything it takes out of the air leaves through one drain line, and a blocked line leaves the water one place to go: rust across the top of a heat exchanger is often a story about the cooling season rather than the heating one. Mention it when you call, because it changes what a contractor expects to find when the cabinet comes open.
Cross Timber, TX in numbers
| Days a year with a low of 32°F or colder | 39 | NOAA 1991–2020 normals, station in or next to town |
|---|---|---|
| Days a year with a low of 20°F or colder | 4 | NOAA 1991–2020 normals |
| Average July dew point | 68°F | PRISM 1991–2020 normals |
| Median year homes were built | 2008 | Census ACS 2019–2023 |
| Households | 304 | Census ACS 2019–2023 |
| County | Johnson County | Census Bureau |
| Federal minimum for a new split central AC | 14.3 SEER2 under 45,000 Btu/h (Southeast) | DOE, 2023 standard |
Furnaces do not fix themselves
Nothing spent on an old furnace transfers to the new one. A large repair on an appliance installed before 2010 buys months rather than years — and if the fault turns out to be the heat exchanger, the gas utility takes the timing out of it altogether: it closes the supply, and the supply comes back only after a licensed contractor has worked on the appliance.
When to stop and call
- The gas utility has tagged the furnace and shut the supply off.
- A technician has said the words heat exchanger, or a carbon monoxide alarm has gone off.
- The part it needs is on back order and the furnace was installed before 2010.
- The figure
- Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
- The call
- Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
- Coverage
- By town, not by region. Cross Timber and the towns around it, and it shifts with who is taking calls at the hour you ring.
What happens on the visit
- 01
The diagnosis
At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.
- 02
The finding, out loud
What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.
- 03
What happens after
A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.
What to have ready when you call from Cross Timber
- 01When the furnace went in, roughly, and its model number — the data plate inside the door carries both.
- 02Whether the gas utility has been out, and what the tag says word for word — the tag usually names the component.
- 03Whether cooling runs through the same ductwork, and what the outdoor data plate gives as the refrigerant — R-410A, R-454B or R-22 — and the model number on that unit, which tells a contractor whether it only cools or heats as well.
The data plate inside the furnace door answers half the call, so have it in front of you — the year it went in and the model number. And if the gas utility left a tag on the appliance, leave the tag where it is: it names what has to be put right before the gas comes back.
Furnace Replacement in Cross Timber: questions
How many freezing days does Cross Timber have?
Cross Timber averages 39 days a year with a low of 32°F or colder and 4 at 20°F or colder, by the 1991–2020 climate normals for the NOAA station in or next to town. Cooling leads here, and the heating runs for a few weeks of the year, so a fault often shows up on the first cold morning.
How old are the homes in Cross Timber?
Half the homes in Cross Timber were built in 2008 or later, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up about half of the housing. Many of those houses still run the equipment they were built with, so its install date is on the label at the furnace or the outdoor unit. Manufactured homes are common enough here that a packaged unit outside, feeding a duct under the floor, is worth mentioning on the call.
How efficient must a new gas furnace be?
A new non-weatherized gas furnace has to reach an AFUE of at least 80 under the federal minimum. DOE has set 95 for furnaces made after December 18, 2028, and that rule is still being fought in court, so a furnace installed now can still be an 80 or a condensing 90-plus.
Other services in Cross Timber
Furnace Replacement nearby