HeatCoolHQ heatcoolhq.com (888) 217-3739

Conway, NH

AC Replacement and Installation in Conway, NH

Replacing an air conditioner in Conway, NH starts with a load calculation for the house, then the efficiency rating the law sets. The July dew point in Conway averages 59°F (PRISM 1991–2020 normals), so moisture is a smaller part of the cooling load here than heat. Half the homes in Conway were built before 1984 (Census ACS 2019–2023). New Hampshire falls in DOE's North region, where a split central air conditioner made since January 1, 2023 must rate at least 13.4 SEER2.

(888) 217-3739

New Hampshire contractors. No obligation for the call.

The year in Conway—heating runs most of the year
The year in Conway. heating runs most of the year. Between the two seasons there are weeks when neither system runs, which is when a fault goes unnoticed. BELOW FREEZINGBELOW FREEZINGnothing runsJFMAMJJASOND
heatingcoolingbelow freezing172 days below freezing · July dew point 59°F
Two technicians lowering a new condenser onto a concrete pad
A new outdoor unit going down on its pad. Where it stands decides how it is serviced for the next fifteen years, and that is settled once.

An air conditioner that no longer holds the house on a hot afternoon is not automatically finished, and what settles it is age, what failed, and what the system is charged with. Say roughly when it went in and what it is doing now, and an independent contractor can come out to Conway and size the replacement from the house rather than from the box being carried out.

What arrives first in a climate like this is the refrigerant question rather than wear. A system installed before about 2010 may be charged with R-22: manufacture of new R-22 equipment stopped in 2010, and production and import of the refrigerant itself ended in 2020. A system charged with R-410A sits differently, because it stays lawful to run, service, repair and recharge, and no end date is attached to that. What did change is what a new system arrives charged with: since 1 January 2025 new residential equipment is no longer manufactured or imported factory-charged with R-410A, and what ships now is charged with R-454B or R-32 instead.

The second machine is usually standing in the same cabinet as the first. Where a furnace and the indoor coil share one, they almost always went in on the same day, and a changeout that replaces one and leaves the other means a contractor opens that cabinet twice. A changeout usually takes about one day, and a heating climate leaves eight months in which that day is not an emergency.

Summer air in Conway is damp enough to matter on the worst afternoons and not much the rest of the time. What water the coil does take out is mostly water the house made — showers, cooking, laundry, the people in the rooms — rather than water drawn in from outside, and that load does not rise and fall with the weather. So the size of a replacement here follows the house: its volume, its windows, what the sun does to it in the afternoon, and how it is lived in. One consequence is worth knowing before a contractor says it out loud — a correctly sized replacement sometimes comes out below the number on the equipment it replaces, because nobody measured when that one went in. Smaller is not a downgrade: a system matched to the house runs longer and holds the temperature steadier than one that overshoots and stops.

Conway, NH in numbers

Days a year with a low of 32°F or colder172NOAA 1991–2020 normals, station 5 miles away
Days a year with a low of 20°F or colder84NOAA 1991–2020 normals
Average July dew point59°FPRISM 1991–2020 normals
Median year homes were built1984Census ACS 2019–2023
Households1,786Census ACS 2019–2023
CountyCarroll CountyCensus Bureau
Federal minimum for a new split central AC13.4 SEER2 (North region)DOE, 2023 standard

What the hardware-store fix does and does not do

Of everything on the shelf, the sealed can with a gauge is what people reach for first, and it deserves an honest answer. A system low on refrigerant does cool badly, and putting refrigerant into it does make it cool better for a while — that part is real. What the can cannot do is find the hole: refrigerant is not used up, so a system that is low is leaking, and the gap between cans gets shorter every time. The cans on the shelf beside the motor oil are charged for car systems, which use a different refrigerant from a home air conditioner, and the ones with a sealant in them add a second problem to the first — sealant can set in the metering device, and it fouls the recovery machine a technician has to connect.

A technician at an indoor air handler

Signs it is time to call

  • You have had refrigerant added in two different seasons.
  • The compressor hums and then trips the breaker, and resetting it is the one thing you can do that makes it worse.
  • Someone has told you to replace the system without having measured the house.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
Coverage
By town, not by region. Conway and the towns around it, and it shifts with who is taking calls at the hour you ring.

What happens on the visit

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  3. 03

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

What to have ready when you call from Conway

  1. 01Roughly when the system went in, and what refrigerant it is charged with — the model number is worth having in front of you too.
  2. 02What the system is doing now — not cooling at all, cooling weakly, running without ever stopping, tripping the breaker, or icing over.
  3. 03What else is in the cabinet with the indoor coil — a furnace, an air handler, nothing you can name — and whether it is the same age.

Read the outdoor data plate before you call — the model number and the refrigerant are printed on it, and those two lines decide most of what follows.

AC Replacement in Conway: questions

What is the July dew point in Conway?

The July dew point in Conway averages 59°F, by the PRISM 1991–2020 climate normals. In air that dry most of the cooling load is heat, and an air conditioner removes little water, so sizing turns on the house and its sun more than on humidity.

When were most houses in Conway built?

Half the homes in Conway were built before 1984, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up about half of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made. Manufactured homes are common enough here that a packaged unit outside, feeding a duct under the floor, is worth mentioning on the call.

Is a new R-410A system still allowed in Conway?

Under federal rules, yes, if the equipment was made or imported before January 1, 2025: an EPA rule that took effect on July 27, 2026 removed the January 1, 2026 installation deadline for that stock. Equipment made since January 1, 2025 is charged with R-454B or R-32 instead, and an outdoor unit built for those is not a listed match for an indoor coil built for R-410A.

Map loads when you reach it

Other services in Conway

AC Replacement nearby

Call (888) 217-3739