HeatCoolHQ heatcoolhq.com (888) 217-3739

Burlington, TX

Heat Pump Repair and Replacement in Burlington, TX

A heat pump in Burlington, TX works in both seasons, so its repair or replacement starts with how it behaves in each. Burlington averages 28 days a year with a low of 32°F or colder and about one at 20°F or colder (NOAA 1991–2020 normals, station 11 miles away). Half the homes in Burlington were built before 1938 (Census ACS 2019–2023), so in many of them the heating and cooling equipment has been replaced at least once while the ducts and the flue have not. The federal minimum for a split heat pump made since January 1, 2023 is 14.3 SEER2 in cooling and 7.5 HSPF2 in heating, nationwide.

(888) 217-3739

Texas contractors. No obligation for the call.

The year in Burlington—cooling runs nearly all year
The year in Burlington. cooling runs nearly all year. There is no month when both systems are idle. JFMAMJJASOND
heatingcooling28 days below freezing · July dew point 70°F
A technician checking the coil of an outdoor heat pump in winter
The top grille off, frost across the coil. A heat pump melts that off on a schedule of its own, which looks like a fault and is not.

A heat pump blowing air that feels cool in winter is usually working as designed, and a heat pump that sits on auxiliary heat for hours in mild weather usually is not. Say what the thermostat reads and a heating and cooling contractor can come out to Burlington and tell the two apart.

Sizing here runs the opposite way from a cold climate: the cooling load sets the size, exactly as it would for an air conditioner, because it is the load that exists for most of the year — which is correct, and it also means that on the handful of genuinely cold mornings the machine runs without stopping and the strips carry what it cannot. Continuous running on a cold morning is the machine doing its job, not failing at it.

The backup that goes in matches the winter this place actually has, which is the sensible way round and has one consequence worth knowing: a strip bank put in for a mild January holds less in reserve than the one the same house would get further north. A freeze that would be unremarkable further north finds that limit, and the house falls behind while the outdoor unit runs and tests fine. The question then is not what broke but whether anything did, and that is a measurement rather than a guess.

A heat pump has to be sized for two different jobs, and in a July this wet the two pull in opposite directions. Size it for the coldest night and it is too large for the cooling season: it drops the temperature, shuts off, and never runs long enough to pull water out of the air, so the thermostat reads 74°F and the house still feels damp. That is where a single-stage machine runs out of options, and it is the argument for a compressor that modulates rather than one that is simply larger — long, slow run cycles are what dehumidify. Ask what the sizing was based on: a measurement of the house, with the heating load and the cooling load worked out separately.

Burlington, TX in numbers

Days a year with a low of 32°F or colder28NOAA 1991–2020 normals, station 11 miles away
Days a year with a low of 20°F or colder1NOAA 1991–2020 normals
Average July dew point70°FPRISM 1991–2020 normals
Median year homes were built1938Census ACS 2019–2023
Households20Census ACS 2019–2023
CountyMilam CountyCensus Bureau
Federal minimum for a new split central AC14.3 SEER2 under 45,000 Btu/h (Southeast)DOE, 2023 standard

Before you try the store-bought fix

The filter is the one item on this list where the store-bought version does something real: a loaded filter starves the indoor coil of air, and a clean one gives that back. What it cannot do is explain a house that is still behind — a furnace with restricted airflow trips its limit switch and announces itself, while a heat pump never makes air hot enough to trip anything: it falls behind, the backup strips make up the difference, and nothing announces anything. That is why a new filter settles nothing on its own: the charge, the defrost control, the reversing valve and the capacitor all sit behind it, and none of those is sold on a shelf.

A technician at an indoor air handler

When to stop and call

  • Ice covers the outdoor coil and the defrost cycles are not clearing it.
  • It cools in summer but will not heat, or it heats but will not cool.
  • The breaker feeding the outdoor unit or the air handler will not stay in.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
Coverage
By town, not by region. Burlington and the towns around it, and it shifts with who is taking calls at the hour you ring.

What the visit involves

  1. 01

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  2. 02

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

Before you call: what to have ready

  1. 01That the system is a heat pump, and what carries the heat when it cannot — electric, or a gas furnace on the same ducts, and not knowing is a fair answer.
  2. 02Both thermostat numbers, and whether the display is showing auxiliary or emergency heat.
  3. 03Roughly what year it went in, and the refrigerant from the outdoor data plate — R-410A on most systems in service, R-454B on recent ones.

Emergency heat is what that setting is for if the house has gone cold, but say on the phone that you switched to it, because it locks out the compressor, and the fault a technician needs to watch stops happening while it is on.

Heat Pumps in Burlington: questions

How many freezing days does Burlington have?

Burlington averages 28 days a year with a low of 32°F or colder and 1 at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 11 miles away. Heating is a handful of mornings here, so a heat pump spends nearly the whole year cooling.

What is the July dew point in Burlington?

The July dew point in Burlington averages 70°F, by the PRISM 1991–2020 climate normals. In air that wet an oversized air conditioner cools the house fast, shuts off before it has dried the air, and leaves rooms cool and clammy, which is why sizing starts with a load calculation for the house.

Does the federal tax credit still cover a new heat pump in Burlington?

No. The 25C energy efficient home improvement credit ended for equipment installed after December 31, 2025, under the tax law signed on July 4, 2025. A quote that subtracts it is out of date, and any utility or state rebate is a separate program to ask the utility about.

Map loads when you reach it

Other services in Burlington

Heat Pumps nearby

Call (888) 217-3739