Burke, TX
Heat Pump Repair and Replacement in Burke, TX
Heat pump repair in Burke, TX starts by telling a normal defrost cycle or auxiliary-heat run from one that is a fault. Burke has, on average, 28 days a year with a low of 32°F or colder and about one at 20°F or colder (NOAA 1991–2020 normals, station in or next to town). Half the homes in Burke were built in 1991 or later (Census ACS 2019–2023). Every split heat pump made since January 1, 2023 has to rate at least 14.3 SEER2 for cooling and 7.5 HSPF2 for heating, the same federal minimum in every state.
(888) 217-3739Texas contractors. No obligation for the call.
A heat pump blowing air that feels cool in winter is usually working as designed, and a heat pump that sits on auxiliary heat for hours in mild weather usually is not. Say what the thermostat reads and a heating and cooling contractor can come out to Burke and tell the two apart.
A heat pump in Burke spends the year on the cooling side, and the heating side is a handful of mornings. What a no-heat call means here depends on what else the house has: where there is a furnace, the heat pump has something to hand the load to, and where there is none — and in this climate plenty of houses have none — the only thing behind it is a bank of electric resistance strips. That is the first thing a technician asks about, because there is no second appliance to switch to.
Sizing here runs the opposite way from a cold climate: the cooling load sets the size, exactly as it would for an air conditioner, because it is the load that exists for most of the year — which is correct, and it also means that on the handful of genuinely cold mornings the machine runs without stopping and the strips carry what it cannot. Continuous running on a cold morning is the machine doing its job, not failing at it.
Sizing a heat pump means sizing for two jobs at once, and in a July this wet they pull against each other. Sized for the coldest night, it is oversized for the cooling season: it drops the temperature, shuts off, and never runs long enough to pull water out of the air, so the thermostat reads 74°F and the house still feels damp. This is the point where a single-stage machine runs out of options, and it is the argument for a compressor that modulates rather than one that is simply larger — long, slow run cycles are what dehumidify. Ask what the size was based on: a measurement of the house, with the heating load and the cooling load worked out separately.
Burke, TX in numbers
| Days a year with a low of 32°F or colder | 28 | NOAA 1991–2020 normals, station in or next to town |
|---|---|---|
| Days a year with a low of 20°F or colder | 1 | NOAA 1991–2020 normals |
| Average July dew point | 72°F | PRISM 1991–2020 normals |
| Median year homes were built | 1991 | Census ACS 2019–2023 |
| Households | 207 | Census ACS 2019–2023 |
| County | Angelina County | Census Bureau |
| Federal minimum for a new split central AC | 14.3 SEER2 under 45,000 Btu/h (Southeast) | DOE, 2023 standard |
What the store-bought fix actually does
The filter is the one thing on this list where the store-bought version does real work: a loaded filter starves the indoor coil of air, and a clean one gives that back. What it cannot do is explain a house that is still behind — a furnace with restricted airflow trips its limit switch and announces itself, while a heat pump never makes air hot enough to trip anything: it falls behind, the backup strips make up the difference, and nothing announces anything. That is why a new filter settles nothing on its own: the charge, the defrost control, the reversing valve and the capacitor all sit behind it, and none of those is sold on a shelf.
When to stop and call
- Ice covers the outdoor coil and the defrost cycles are not clearing it.
- It cools in summer but will not heat, or it heats but will not cool.
- Refrigerant was added in an earlier season and the system is behaving the same way again.
- The license
- Held by the contractor, not by this site, and issued where the work happens — Texas licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
- The call
- Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
- Coverage
- By town, not by region. Burke and the towns around it, and it shifts with who is taking calls at the hour you ring.
What a visit in Burke involves
- 01
The diagnosis
At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.
- 02
The finding, out loud
What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.
- 03
What happens after
A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.
Before you call: what to have ready
- 01That the system is a heat pump, and what carries the heat when it cannot — electric, or a gas furnace on the same ducts, and not knowing is a fair answer.
- 02Both thermostat numbers, and whether the display is showing auxiliary or emergency heat.
- 03What the outdoor unit is doing: iced over, silent, running without stopping, or reversing every few minutes.
If the house has gone cold, emergency heat is what that setting is for — say on the phone that you switched to it, because it locks out the compressor, and the fault a technician needs to watch stops happening while it is on.
Heat Pumps in Burke: questions
How many freezing days does Burke have?
Burke averages 28 days a year with a low of 32°F or colder and 1 at 20°F or colder, by the 1991–2020 climate normals for the NOAA station in or next to town. Heating is a handful of mornings here, so a heat pump spends nearly the whole year cooling.
How humid are summers in Burke?
The July dew point in Burke averages 72°F, by the PRISM 1991–2020 climate normals. In air that wet an oversized air conditioner cools the house fast, shuts off before it has dried the air, and leaves rooms cool and clammy, which is why sizing starts with a load calculation for the house.
How efficient must a new heat pump in Burke be?
The federal minimum for a split heat pump made since January 1, 2023 is 14.3 SEER2 for cooling and 7.5 HSPF2 for heating, the same in Texas as in every other state. The rating of the matched outdoor unit and coil is on the AHRI certificate, and a quote for Burke can go above the minimum.