AC Repair in Bishopville

Winter in Bishopville comes in stretches of a few weeks rather than as a season, and the cooling side is what carries the year.

Almost every call here comes back to the outdoor unit, because the cooling side is the half that gets used. Run hours wear out a compressor, a contactor and an outdoor fan motor, so summers worked says more about a compressor than the year on the data plate does: a system installed in 2011 that has cooled through every summer since has more behind it than the install date alone shows. Where the same outdoor unit heats the house as well, which is what a heat pump does, nothing in the year gives it a rest.

The outdoor coil matters more here than it does somewhere cooler. Cooling works by dumping heat outside, and on the hottest afternoons of the year there is less cool air to dump it into; a coil packed with cottonwood seed, grass clippings or dryer lint takes away what little margin is left. A system that coped in June and quits in August is often reporting the coil, not the compressor.

July air here carries enough water that the AC spends much of its run time removing it rather than dropping the temperature, and that changes what a fault sounds like. A house that reaches the set temperature and still feels clammy is reporting something real: the system is falling short on the water half of the job, whether from a low charge, too much air moving across the coil, or a unit that satisfies the thermostat before it has taken any water out and shuts off. It changes one of the readings as well. The temperature split across the coil reads lower in a damp house than in a dry one on the same healthy system, because part of the capacity is going into water instead of into the thermometer — so a split that looks weak in Bishopville is not automatically a weak system, and a technician takes that reading together with what the house feels like rather than instead of it.

The filter is the one thing on the shelf that genuinely belongs to this fault, and being fair about it costs nothing: a filter gone gray stops enough air to freeze a coil, it is the first thing a technician checks for exactly that reason, and a system that iced up because of one wants it changed before anything else. A new filter reaches none of what sits on the other side of it: a charge that has leaked away, a capacitor that has drifted, an outdoor coil packed solid, a blower wheel silted up blade by blade. Nor does it clear the ice already on the coil, which needs the cooling off, the fan on and several hours. A system that froze with a clean filter in it has already ruled the filter out, and that is worth saying on the phone.

The can of refrigerant with sealant in it is the one to leave on the shelf. The sealant is made to harden where it meets air, and inside a system it hardens in the metering device, the filter drier and the recovery equipment — and it does not come back out of a recovery machine, which is why a system that has had it is a harder system to get worked on. The gauge on the can cannot tell a low charge from a dirty coil, a blocked filter or a restricted metering device, and all four read low on the same needle. A technician weighs the charge in against a measurement instead of adding it until the air feels colder. Refrigerant for a home system is not a retail purchase either: EPA rules restrict the sale of it to certified technicians, and what has turned up on the shelf as a drop-in for R-22 has at times been a flammable hydrocarbon blend.

The hard-start kit is not a gimmick, and it does a real job — it adds torque for the half-second a compressor needs to break away, and a technician fits one on purpose. It diagnoses nothing. A compressor that started without help last summer and needs help this one has changed, and the kit lets it go on starting while whatever changed carries on. Fitted after a measurement it buys time deliberately; fitted instead of one, it hides the reading that would have said how much time there is.