HeatCoolHQ heatcoolhq.com (888) 217-3739

Alpine, TX

Heat Pump Repair and Replacement in Alpine, TX

Heat pump repair in Alpine, TX starts by telling a normal defrost cycle or auxiliary-heat run from one that is a fault. Alpine has, on average, 56 days a year with a low of 32°F or colder and 7 at 20°F or colder (NOAA 1991–2020 normals, station in or next to town). Half the homes in Alpine were built before 1979 (Census ACS 2019–2023). The federal minimum for a split heat pump made since January 1, 2023 is 14.3 SEER2 in cooling and 7.5 HSPF2 in heating, nationwide.

(888) 217-3739

Texas contractors. No obligation for the call.

The year in Alpine—cooling leads, heating gets weeks
The year in Alpine. cooling leads, heating gets weeks. Between the two seasons there are weeks when neither system runs, which is when a fault goes unnoticed. nothing runsJFMAMJJASOND
heatingcooling56 days below freezing · July dew point 56°F
A technician checking the coil of an outdoor heat pump in winter
The top grille off, frost across the coil. A heat pump melts that off on a schedule of its own, which looks like a fault and is not.

A heat pump blowing air that feels cool in winter is usually working as designed, and a heat pump that sits on auxiliary heat for hours in mild weather usually is not. Say what the thermostat is showing and a heating and cooling contractor can come out to Alpine and tell the two apart.

In Alpine a heat pump spends most of its life as an air conditioner, and the heating side runs for a few weeks rather than a season. That decides which faults get noticed and when: anything wrong with cooling shows up in July with the whole house paying attention, while anything wrong with heating waits for the first cold week of the year to announce itself.

A gas furnace and a heat pump deliver heat at different temperatures, and the gap is wide. A heat pump supplies air nearer 95°F where a gas furnace supplies it nearer 130°F, and air that arrives near skin temperature, moving, reads as cool — which is why the complaint arrives every year from houses with nothing wrong. What counts is whether the house reaches the setting, and how long it stays short of it: air that feels cool with the house holding at the setting is the machine working, and air that feels cool with the house still short of it at bedtime is not.

Summer air here holds less water than it does further east, and air that holds less water sheds heat faster once the sun is down. That puts a wide gap between afternoon and dawn, and in spring and autumn a heat pump answers both ends of it in a single day — cooling in the afternoon, heating before sunrise, with nobody switching anything over. What it costs is hidden in the thermostat: set the heating and cooling numbers close together and the system changes direction several times a day, and every change is the reversing valve moving and the compressor starting again. Ask what the changeover band is set to — it is a setting, not a repair.

Alpine, TX in numbers

Days a year with a low of 32°F or colder56NOAA 1991–2020 normals, station in or next to town
Days a year with a low of 20°F or colder7NOAA 1991–2020 normals
Average July dew point56°FPRISM 1991–2020 normals
Median year homes were built1979Census ACS 2019–2023
Households3,242Census ACS 2019–2023
CountyBrewster CountyCensus Bureau
Federal minimum for a new split central AC14.3 SEER2 under 45,000 Btu/h (Southeast)DOE, 2023 standard

Heat pumps do not fix themselves

What makes a heat pump different is that it can fail without ever going quiet. A machine low on refrigerant, or one whose defrost control has stopped working, does not stop making heat — it falls behind, and the backup heat fills the gap without being asked. The house stays at the setting, so the fault reports itself on the electric bill instead of at the thermostat. The same shortfall in cooling is easier to spot, because nothing covers for it — which is why a heat pump often gets diagnosed in summer for something it had been doing all through the heating season.

A technician at an indoor air handler

Signs it is time to call

  • The thermostat sits on auxiliary or emergency heat for hours while it is mild outside.
  • It cools in summer but will not heat, or it heats but will not cool.
  • Refrigerant was added in an earlier season and the system is behaving the same way again.
The license
Held by the contractor, not by this site, and issued where the work happens — Texas licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
Coverage
By town, not by region. Alpine and the towns around it, and it shifts with who is taking calls at the hour you ring.

What a visit in Alpine involves

  1. 01

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  2. 02

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

Before you call: what to have ready

  1. 01That the system is a heat pump, and what carries the heat when it cannot — electric, or a gas furnace on the same ducts, and not knowing is a fair answer.
  2. 02Roughly when it was installed, and what the outdoor data plate says it is charged with — R-410A on most systems in service, R-454B on recent ones.
  3. 03The address and ZIP code, and whether the outdoor unit can be reached — a locked gate, a dog or deep snow changes the appointment.

If the house has gone cold, emergency heat is what that setting is for — say on the phone that you switched to it, because it locks out the compressor, and the fault a technician needs to watch stops happening while it is on.

Heat Pumps in Alpine: questions

How many freezing days does Alpine have?

Alpine averages 56 days a year with a low of 32°F or colder and 7 at 20°F or colder, by the 1991–2020 climate normals for the NOAA station in or next to town. Cooling sizes the equipment here, and the few cold mornings are when the backup heat comes on.

How humid are summers in Alpine?

The July dew point in Alpine averages 56°F, by the PRISM 1991–2020 climate normals. In air that dry most of the cooling load is heat, and an air conditioner removes little water, so sizing turns on the house and its sun more than on humidity.

Is a new R-410A system still allowed in Alpine?

Federally, yes, for equipment made or imported before January 1, 2025: the EPA dropped the January 1, 2026 installation deadline for that stock in a rule effective July 27, 2026. What has been made since January 1, 2025 runs on R-454B or R-32, and those outdoor units are not a listed match for a coil built for R-410A.

Map loads when you reach it

Other services in Alpine

Heat Pumps nearby

Call (888) 217-3739