Alice Acres, TX
Furnace Replacement and Installation in Alice Acres, TX
A new furnace in Alice Acres, TX is sized from the house, its ducts and its winters, not from the rating plate of the one coming out. Alice Acres has, on average, 4 days a year with a low of 32°F or colder and almost none at 20°F or colder (NOAA 1991–2020 normals, station 3 miles away). Half the homes in Alice Acres were built in 2002 or later (Census ACS 2019–2023). A new non-weatherized gas furnace has to reach an AFUE of at least 80, the federal minimum; DOE has set 95 for furnaces made after December 18, 2028, a rule still being fought in court.
(888) 217-3739Texas contractors. No obligation for the call.
A furnace with one failed part and a furnace on its second service call of the season are asking different questions. Say roughly when it was installed and what it is doing, and a heating contractor can come out to Alice Acres and answer that before anything is ordered.
In Alice Acres a furnace works a few weeks of the year, and some years barely that. The calendar comes out of the decision first: a changeout takes about one day, and a day without heat here is an inconvenience rather than a risk. So the timing follows the appliance instead of the other way around.
What low hours change is the way a furnace ends, not whether it ends. A furnace here stands still more than it runs: a flue that never gets hot enough to dry itself out, condensate sitting in a trap through a warm winter, corrosion working on the burners from the outside in. Corrosion reaches the heat exchanger before cycling would have, and the ending is the same one.
The blower comes with the furnace, and it runs in July as well as in January, which makes a changeout here a cooling decision as much as a heating one. In July most of the work is water rather than temperature: a system that cools fast, shuts off and leaves the rooms cold and clammy did not run long enough to dehumidify. The question worth asking is what the new blower does at part load, because one that holds a lower airflow for a longer cycle takes more water out of the same house.
Alice Acres, TX in numbers
| Days a year with a low of 32°F or colder | 4 | NOAA 1991–2020 normals, station 3 miles away |
|---|---|---|
| Days a year with a low of 20°F or colder | fewer than one | NOAA 1991–2020 normals |
| Average July dew point | 72°F | PRISM 1991–2020 normals |
| Median year homes were built | 2002 | Census ACS 2019–2023 |
| Households | 135 | Census ACS 2019–2023 |
| County | Jim Wells County | Census Bureau |
| Federal minimum for a new split central AC | 14.3 SEER2 under 45,000 Btu/h (Southeast) | DOE, 2023 standard |
Furnaces do not fix themselves
A cracked heat exchanger does not stay the size it was when somebody found it. Every heating cycle opens it further, because heat moves the steel and the crack is where that movement collects.
When to stop and call
- The gas utility has tagged the furnace and shut the supply off.
- Flame rolls out of the burner opening, or there is soot around the furnace door.
- The part it needs is on back order and the furnace was installed before 2010.
- The license
- Held by the contractor, not by this site, and issued where the work happens — Texas licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
- The call
- Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
- Coverage
- By town, not by region. Alice Acres and the towns around it, and it shifts with who is taking calls at the hour you ring.
What the visit involves
- 01
The finding, out loud
What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.
- 02
The repair
Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.
- 03
What happens after
A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.
What to have ready when you call
- 01Roughly when the furnace was installed, and the model number — the data plate inside the door carries both.
- 02Whether the gas utility has already been there, and the wording on the tag — the tag usually names the component.
- 03Where the furnace sits and what it vents into — a metal flue into a chimney, or a white plastic pipe through the wall — and whether a water heater shares that chimney, because one left alone on a flue sized for two appliances becomes its own piece of work. The address and ZIP code go with that.
The data plate inside the furnace door answers half the call, so have it in front of you — the year it went in and the model number. And if the gas utility left a tag on the appliance, leave the tag where it is: it names what has to be put right before the gas comes back.
Furnace Replacement in Alice Acres: questions
How cold does Alice Acres get in winter?
Alice Acres averages 4 days a year with a low of 32°F or colder and almost none at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 3 miles away. Heating is rarely asked for here, so a fault in it can sit unnoticed until the one cold week of the year.
How old are the homes in Alice Acres?
Half the homes in Alice Acres were built in 2002 or later, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up a good share of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made. Manufactured homes are common enough here that a packaged unit outside, feeding a duct under the floor, is worth mentioning on the call.
What does a red tag on a furnace in Alice Acres mean?
The gas utility red-tags a furnace when it finds a leak or an unsafe appliance, and it shuts the gas off to it. The gas stays off until a contractor repairs the fault, and a cracked heat exchanger is often where a red tag turns a repair into a replacement.
Other services in Alice Acres
Furnace Replacement nearby